Viewing page 2 of 5
00:05:50
00:10:14
00:05:50
This transcription has been completed. Contact us with corrections.
Transcription: [00:06:05]
[[silence]]
{SPEAKER name="Speaker CLTC"}
CLVM CLTC
{SPEAKER name="Speaker CLVM"}
CLVM.
[00:06:13]
{SPEAKER name="Speaker CLTC"}
Did you pick up the instructions keep the pad safety plate?
{SPEAKER name="Speaker CLVM"}
Wilco.
{SPEAKER name="Speaker CLTC"}
C1SB CLTC Will you get the TCSRMP for pad safety?
[00:06:24]
{SPEAKER name="Speaker 1"}
Wilco.
[00:06:24]
{SPEAKER name="Speaker CLTC"}
Thank you.
BTMC CLTC Will you verify LCCTM check guide equipment ready to support DRS post loop test?
[00:06:32]
{SPEAKER name="Speaker BTMC"}
BMTC verifies
{SPEAKER name="Speaker CLTC"}
CLTC on 121 will pick up the rain checks approx, approximately 6 or 7 minutes early.
[00:06:42]
All DP, CLTC verify all switches in auto positions except PD receiver enabled to off. Set status switch to safe. Status switch to safe.
[00:06:54]
{SPEAKER name="Speaker unknown"}
Verify.
{SPEAKER name="Speaker unknown"}
Verified.
{SPEAKER name="Speaker T4"}
T4 verifies.
{SPEAKER name="Speaker T2"}
T2 verifies.
{SPEAKER name="Speaker T1"}
T1 verifies.
[00:07:01]
{SPEAKER name="Speaker CLTC"}
T1? All right.
VDP's verify SNA safe and receivers PD blocked on.
[00:07:06]
{SPEAKER name="Speaker T1"}
T1 verifies.
{SPEAKER name="Speaker T2"}
T2 verifies.
{SPEAKER name="Speaker T4"}
T4 verifies.
{SPEAKER name="Speaker CLTC"}
CLVN to construct to enable.
[00:07:12]
{SPEAKER name="Speaker CLVN"}
Construct enable.
{SPEAKER name="Speaker CLTC"}
BTMC TM tape recorder on for DRMC test, test.
[00:07:18]
{SPEAKER name="Speaker BTMC"}
BTMC recorder on.
{SPEAKER name="Speaker CLTC"}
RSC verify the DRSC recorders on.
{SPEAKER name="Speaker RSC"}
RSC verifies.
{SPEAKER name="Speaker CLTC"}
BRFS CLTC sig gen on and verify remote monitor to i-route.
[00:07:37]
{SPEAKER name="Speaker BRFS"}
BRFS verifies.
{SPEAKER name="Speaker CLTC"}
All DP's, system set switch to off.
{SPEAKER name="Speaker T1"}
Verify.
{SPEAKER name="Speaker T2"}
T2 verifies.
{SPEAKER name="Speaker T4"}
T4 verifies.
[00:07:44]
{SPEAKER name="Speaker CLTC"}
C2MP activate battery B switches as required.
{SPEAKER name="Speaker C2MP"}
C2MP wilco.
{SPEAKER name="Speaker CLTC"}
C4MP will you verify at 4 D 20 and 30 battery orders in tolerance?
[00:07:55]
{SPEAKER name="Speaker C4MP"}
C4 verifies.
{SPEAKER name="Speaker CLTC"}
All DPs receiver internal and verify?
{SPEAKER name="Speaker T1"}
T1, number 1 to internal, number 2 internal, verify.
[00:08:03]
{SPEAKER name="Speaker T2"}
T2, number 1 to internal, number 2 internal, verify on.
{SPEAKER name="Speaker T4"}
T4, number 1 internal, number 2 internal, verified on.
[00:08:10]
{SPEAKER name="Speaker CLTC"}
1, 2 and 4 are F verified are CR vector village are OK.
[00:08:14]
{SPEAKER name="Speaker T1"}
T1 verifies.
{SPEAKER name="Speaker T2"}
T2 verifies.
{SPEAKER name="Speaker T4"}
T4 verifies.
{SPEAKER name="Speaker CLTC"}
BP's verify EBW is external and not charged.
[00:08:20]
{SPEAKER name="Speaker T1"}
T1 verifies.
{SPEAKER name="Speaker T2"}
T2 verifies.
{SPEAKER name="Speaker T4"}
T4 verifies.
{SPEAKER name="Speaker CLTC"}
BP's is center receivers cut off indications go on simultaneously switched EBWs to external then to auto.
[00:08:32]
{SPEAKER name="Speaker T1"}
T1 copies.
{SPEAKER name="Speaker T2"}
T2 copies.
{SPEAKER name="Speaker T4"}
T4 copies.
{SPEAKER name="Speaker CLTC"}
Recorders fast?
{SPEAKER name="Speaker unknown"}
Recorders fast.
[00:08:38]
{SPEAKER name="Speaker CLTC"}
SRO on your mark then cut off on closed loop link for 3 seconds.
{SPEAKER name="Speaker SRO"}
Wilco. Stand by
3 - 2 - 1 mark
Take it away.
[00:08:53]
{SPEAKER name="Speaker CLTC"}
Recorders slow?
{SPEAKER name="Speaker Unknown"}
Recorders slow.
{SPEAKER name="Speaker CLTC"}
BPs verify that EBWs are internal and charged while receivers cut off indications were on.
[00:08:59]
{SPEAKER name="Speaker T2"}
T2 verifies.
{SPEAKER name="Speaker T4"}
T4 verifies.
{SPEAKER name="Speaker T1"}
T1 verifies.
{SPEAKER name="Speaker CLTC"}
EDPs verify EBW is external and not charged.
[00:09:09]
{SPEAKER name="Speaker T1"}
T1.
{SPEAKER name="Speaker T2"}
T2 verifies.
{SPEAKER name="Speaker C4"}
T4 verifies.
{SPEAKER name="Speaker CLTC"}
BPs verify S and A divide safe and receivers PD blocked.
[00:09:19]
{SPEAKER name="Speaker T1"}
T1 verifies.
{SPEAKER name="Speaker T2"}
T2 verifies.
{SPEAKER name="Speaker T4"}
T4 verifies.
{SPEAKER name="Speaker CLTC"}
Recorders fast?
[00:09:27]
{SPEAKER name="Speaker unknown"}
Recorders fast
{SPEAKER name="Speaker CLTC"}
SRO on your marks in PD command on closed looping for one second.
{SPEAKER name="Speaker SRO"}
Wilco.
3 - 2 - 1 mark
Take it away
[00:09:41]
{SPEAKER name="Speaker CLTC"}
Recorders slow?
{SPEAKER name="Speaker unknown"}
Recorders slow.
{SPEAKER name="Speaker CLTC"}
BPs verify receivers PD received.
[00:09:45]
{SPEAKER name="Speaker T1"}
T1 verifies.
{SPEAKER name="Speaker T2"}
T2 verifies.
{SPEAKER name="Speaker T4"}
T4 verifies.
{SPEAKER name="Speaker CLTC"}
BPs verify EBWs did not charge.
[00:09:50]
{SPEAKER name="Speaker T1"}
T1 verifies.
{SPEAKER name="Speaker T2"}
T2 verifies.
{SPEAKER name="Speaker T4"}
T4 verifies.
{SPEAKER name="Speaker CLTC"}
Tape recorder off and reload.
{SPEAKER name="Speaker BTMC"}
BTMC recorder off.
[00:09:59]
{SPEAKER name="Speaker CLTC"}
Yep.
[[silence]]
[00:10:15]
