Viewing page 4 of 13

This transcription has been completed. Contact us with corrections.

allow today for a few minutes. 
raise screen- then carefully
remove - paper layer from film.

----------------------------------------------
(if stray pieces of film adhere, melt them out with lacquer thinner which is used also for removing all film when after all printing (carefully)
wiping it off quickly or brush pieces out with needle pt. thru screen.

block out all areas around stencil (not covered by film & which are not to print with glue or paper (first squegee inkimp with hold paper to screen
Then Print
Keep lacquer thinner off border edges of screen [[strikethrough]] with [[/strikethough]] that have lacquered areas as it removes lacquer.