Viewing page 86 of 272

This transcription has been completed. Contact us with corrections.

BERNSTEIN BROS. SHEET METAL SPECIALTIES, Inc.
Designers - Fabricators
41-18 24th STREET   ST 6-0700
Long Island City, N. Y. 11101

STAINLESS STEEL CORE

The sculpture is a single unit mounted on the floor and consists of inner and outer sections connected by end panels.

The inner core is composed of four (4) sheets, forming a rectangular tube 34"x19"x68" long. Material is #14ga. Stainless Steel type #304 polished #3 finish. Corner seams are Heliarc welded to give sharp, square inside corners, without penetration or severe burning. Discoloration on the inside is removed by means of electro-polishing.

The end panels are composed of four (4) plates welded into a rectangle 33"x48" with an inside opening 34"x19" at which point the inner core is fused. This is done at both ends of inner core is fused. This is done at both ends of inner core. Each end panel is fabricated of 3/16" Stainless Steel type #304. Welding of inner core and end plates is ground so as to remove all signs of weld and inside corners are electropolished to remove discoloration. All grain lines are blended.

Outer section of three (3) acrylic plastic panels fastened to end plates at outer edge of end plates to small clips ahich have been fused into place. Small Stainless Steel machine screws and Stailess Steel pins retain the plastic.

Stainless Steel was chosen for this sculpture to utilize its beauty, long life, ease of fabrication and finishing properties.


CUSTOM PRODUCTIONS FOR INDUSTRY