Viewing page 251 of 606

This transcription has been completed. Contact us with corrections.

-2-
R. Rathbun, Esq.

the feet to be provided with the leveler bolts.

The cases should be 2nd from under side of glass to slanting bot-tom which should be removable and there should be roll-holders at each end of the removable bottoms 5th in each direction from the center. This makes a space 10" between the outer edges o the holders and the holders should be 1-1/2" in diameter.

Where the sections of the case join there should be 5/16 of an inch on each side of the joint, and the total amount covered only 5/8 of an inch. 11 sections should be bolted together and the cases to be dust-proof with felt under the door frame. 

The tops of the cases at back should be 35" above floor. 

Of those eleven show-cases three are 16 inches wide on the slanting bottom and eight are 16 inches wide on the slanting bottom. All lengths are taken inside between the ends and are as follows:

One show-case 10' 0" Long; 18" Wide.
One show-case 21' 0" Long; 18" Wide. Made in two sections.
One show-case 36' 6" Long; 18" Wide. Made in three sections.
Four show-cases 8' 0" Long; 16 Wide.
Three show-cases 10' 0" Long; 16" Wide.
One show-case 18' 6" Long; 16" Wide.

To aid your superintendent in checking this order, I am taking the 

Transcription Notes:
---------- Reopened for Editing 2023-05-25 14:20:55